Edge-lighting 4" Power Feed Canopies Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Edge-lighting 4" Power Feed Canopies herunter. Edge Lighting 4" Power Feed Canopies User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
SAVE THESE INSTRUCTIONS!
MP-4RD-1-_
- This product is ETL listed for indoor dry locations.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).
- This product should be installed by a qualified electrician.
A
1: Turn the power to electrical box off.
2: Connect each low voltage wire coming from the remote
transformer to one power feed canopy wire with a wire nut.
Monorail 4" Round Single Power Feed Canopy
Installation Instructions for
Install the Canopy
1
904-MP-4RD-1-03
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
2
NOTE: Use the universal round crossbar (provided) if the electrical
box holes are not spaced 2-3/4" apart.
NOTE: The low voltage wires should be present in the electrical
box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.
2
B
4
3: Place all wires inside the electrical box.
4: Secure the power feed canopy to the electrical box by
tightening the two provided #8-32 screws with the 3/32
Allen wrench.
3/32 ALLEN
WRENCH
4
#8-32
SCREW
© 2009 Edge Lighting. All Rights Reserved.
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - Install the Canopy

SAVE THESE INSTRUCTIONS!MP-4RD-1-_- This product is ETL listed for indoor dry locations.- This product can be installed to a 4" electrical box wi

Seite 2

CCAP3/8-24 SET SCREWPOWER HOUSING213/16 ALLEN WRENCHCAP21: Unscrew the cap from power housing.2: Slightly loosen the 3/8-24 set screw on the cap with

Kommentare zu diesen Handbüchern

Keine Kommentare