Edge-lighting Cirrus Float Center Feed Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Edge-lighting Cirrus Float Center Feed herunter. Edge Lighting Cirrus Float Center Feed User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 3
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
SAVE THESE INSTRUCTIONS!
- This product is suitable for indoor locations.
- This instruction shows a typical instruction.
IMPORTANT INFORMATION
Installation Instructions for Cirrus Float Center Feed
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2013 Edge Lighting. All Rights Reserved.
1
904-CF-D1-C-01
CF-D1-C-_
A
1: Loosen and remove the six Phillips screws from the canopy
to remove the mounting plate.
Install the Fixture
PHILLIPS SCREW
1
1
MOUNTING PLATE
CANOPY
1
B
2 Align the mounting plate holes with the electrical box holes
and mark a point through the mounting plate holes onto the
ceiling. These points are used for the anchors.
:
MOUNTING PLATE
ELECTRICAL BOX HOLE
2 2
C
3
4
ANCHOR
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
D
#8-32 SCREW
CROSSBAR ASSEMBLY
5: Feed the power wires through the crossbar assembly
center hole.
6: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.
5
6
6
NOTE: It is recommended more than one person to assist in
this installation
Seitenansicht 0
1 2 3

Inhaltsverzeichnis

Seite 1 - Install the Fixture

SAVE THESE INSTRUCTIONS!- This product is suitable for indoor locations.- This instruction shows a typical instruction.IMPORTANT INFORMATIONInstallati

Seite 2

EMOUNTING PLATENUTPOWER WIRE7: crossbar threaded nipple and secure it with the nut provided. Slide the cover and mounting plate center hole onto th

Seite 3 - GENERAL WIRING DIAGRAM

3JPOWER SUPPLYCANOPY11: Connect each coaxial cable bare wire to the low voltage red power supply wires with a wire nut.COAXIAL CABLE1314K1212: M

Kommentare zu diesen Handbüchern

Keine Kommentare