Edge-lighting Crystal Galaxy Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Edge-lighting Crystal Galaxy herunter. Edge Lighting Crystal Galaxy User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
FJ-CRYGA16-12-SN
Installation Instructions for Crystal Galaxy
1
904-FJ-CRYGA16-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- Use this fixture indoors only.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- This product is ETL listed for indoor dry locations and
approved to be used at any height above the finished
floor.
IMPORTANT INFORMATION
Adjust the Fixture Height
A
H
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the crystals to the end of the coaxial cable.
B
M4 SET SCREW
M3 SET
SCREW
1.5MM ALLEN
WRENCH
2MM ALLEN
WRENCH
2
3
COAXIAL FIXTURE CONNECTOR
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
CRYSTAL
COAXIAL CABLE
1
Seitenansicht 0
1 2 3 4

Inhaltsverzeichnis

Seite 1 - Crystal Galaxy

FJ-CRYGA16-12-SNInstallation Instructions for Crystal Galaxy1904-FJ-CRYGA16-011718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5613

Seite 2

22CCONICAL NIPPLESTRAIN RELIEF TUBECOAXIAL CABLE44: Feed the coaxial cable through the conical nipple and flared side of the strain relief tube. S

Seite 3 - CIRCUIT #2

312N12N1111121211: Use fingers to tighten the Fast Jack fixture connector into the Fast Jack system connector (Monorail, Monorail 2 Circui

Seite 4 - Install the Lamp

4Install the Lamp HCAUTION: To reduce risk of a burn or electrical shock during lamping, disconnect the power to the fixture. LAMP 1: Screw each lamp

Kommentare zu diesen Handbüchern

Keine Kommentare